Frigidaire FHWC3640MS Manuel du propriétaire télécharger pdf (Page 5)

LIST OF MATERIALS

Parts included in your hood

4 - 0.45 x 1.3 cm mounting screws

2 - .35 x .65 cm rectangular vent transition

mounting screws

2 - .29 x .65 cm round metal mounting plate

mounting screws

3¼” x 10” (8.3 x 25.4 cm) rectangular metal vent

system.

7” (17.8 cm) round metal mounting plate.

Parts Needed

2 - UL listed wire connectors

Wall or roof cap with damper to match vent system

Vent clamps/duct tape as required

UL listed or CSA approved ½” strain relief

Tools/Materials required

Drill

1¼” (3.0 cm) drill bit

⅛” (0.3 cm) drill bit for pilot holes

Pencil

Wire stripper or utility knife

Tape measure or ruler

Caulking gun and weatherproof

caulking compound

Flat-blade screwdriver

Phillips screwdriver

Saber or keyhole saw

For cabinets with recessed bottoms:

Two - 2” (5.1 cm) wide ller strips. Length and

thickness determined by recess dimensions.

Four at head wood screws or machine screws

with washers and nuts (to attach ller strips).

•

ELECTRICAL REQUIREMENTS

Observe all governing codes and ordinances.

Ensure that the electrical installation is adequate and in

conformance with National Electrical Code, ANSI/NFPA

70 (latest edition), or CSA Standards C22.1-94, Canadian

Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edi-

tion) and all local codes and ordinances.

If codes permit and a separate ground wire is used, it is

recommended that a qualied electrician determine that

the ground path is adequate.

A copy of the above code standards can be obtained

from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

A 120 volt, 60 Hz., AC only, 15-amp, fused electrical

circuit is required.

If the house has aluminum wiring, follow the

procedure below:

Connect a section of solid copper wire to the

pigtail leads.

Connect the aluminum wiring to the added

section of copper wire using special co

nectors and/or tools designed and UL listed

for joining copper to aluminum.

Follow the electrical connector manufacturer’s recom-

mended procedure. Aluminum/copper connection must

conform with local codes and industry accepted wiring

practices.

Wire sizes and connections must conform with

the rating of the appliance as specied on the

model/serial rating plate.

The model/serial plate is located on the left side of

the range hood.

Wire sizes must conform to the requirements of

the National Electrical Code, ANSI/NFPA 70 (la

est edition), or CSA Standards C22. 1-94, Canad

an Electrical Code, Part 1 and C22.2 No. 0-M91

(latest edition) and all local codes and ordinances.

•

1 2 3 4 5 6 7 8 9 10 ... 16 17

Commentaires sur ces manuels

Pas de commentaire

Frigidaire FHWC3640MS Manuel du propriétaire Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine Frigidaire FHWC3640MS