Frigidaire FGHN2866PP Manuel d'utilisateur télécharger pdf (Page 14)

14

WARNING

To avoid electric shock, which can cause

death or severe personal injury, disconnect

the refrigerator from electrical power before

connecting a water supply line to the

refrigerator.



NOTE

Check with your local building authority

for recommendations on water lines and

associated materials prior to installing your

new refrigerator. Depending on your local/

state building codes, Frigidaire recommends

for homes with existing valves its Smart

Choice

®

water line kit 5305513409 (with

a 6 ft. Stainless Steel Water Line) and for

homes without an existing valve, Frigidaire

recommends its Smart Choice

®

water line

kit 5305510264 (with a 20 ft. Copper Water

Line with self-tapping saddle valve). Please

refer to www.frigidaire.com/store for more

information.

CAUTION

To Avoid Property Damage:

• Copper or Stainless Steel braided tubing

is recommended for the water supply

line. Water supply tubing made of ¼

inch plastic is not recommended to be

used. Plastic tubing greatly increases

the potential for water leaks, and the

manufacturer will not be responsible for

any damage if plastic tubing is used for

the supply line.

• DO NOT install water supply tubing in

areas where temperatures fall below

freezing.

• Chemicals from a malfunctioning softener

can damage the ice maker. If the ice

maker is connected to soft water, ensure

that the softener is maintained and

working properly.

IMPORTANT

Ensure that your water supply line

connections comply with all local plumbing

codes.

CONNECTING THE WATER SUPPLY

Before Installing The Water Supply Line,

You Will Need:

• Basic Tools:adjustablewrench,at-blade

screwdriver, and Phillips

TM

screwdriver

• Access to a household cold water line with

water pressure between 30 and 100 psi.

• A water supply line made of ¼ inch (6 mm)

OD, copper or stainless steel tubing. To

determine the length of tubing needed,

measure the distance from the ice maker

inlet valve at the back of the refrigerator

to your cold water pipe. Then add

approximately 7 feet (2.1 meters), so the

refrigerator can be moved out for cleaning

(as shown).

• A shutoff valve to connect the water supply

line to your household water system. DO

NOT use a self-piercing type shutoff valve.

• Donotreusecompressionttingoruse

thread seal tape.

• A compression nut and ferrule (sleeve) for

connecting a copper water supply line to the

ice maker inlet valve.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Commentaires sur ces manuels

Pas de commentaire