28
CHANGING THE FILTER
Locating the Filters
Your refrigerator is equipped with water
ltering system. The water lter system lters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
The water lter is located at the top right side
of the fresh food compartment.
Ordering Replacement Filters
To order your replacement lters, please visit
our online store at www.frigidaire.com/store,
by calling toll-free at 877-808-4195, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
order extra lters when you rst install your
refrigerator, and that you replace your lters at
least once every six months.
Here is the product number to request when
ordering:
PureSource Ultra
TM
Water Filter
Part #ULTRAWF
Replacing the Water Filter
In general, you should change the water
lter every six months to ensure the highest
possible water quality. The Water Filter
Status light on the user interface prompts you
to replace the lter after a standard amount of
water (200 gallons/757 liters for PureSource
Ultra
TM
)
has owed through the system. The
water lter status light on this model is not
performance tested or certied by NSF.
If your refrigerator has not been used for a
period of time (during moving for example),
change the lter before reinstalling the
refrigerator.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certied for cyst reduction may be used on
disinfected waters that may contain lterable cysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
ice and water lter
• Rated service ow - .50 gallons per minute
• Operating Temp.: Min. 33° F, Max. 100° F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure:
30 pounds per square inch
To replace your PureSource Ultra
TM
water lter:
It is not necessary to turn the water supply off
to change the lter. Be ready to wipe up any
small amounts of water released during the lter
replacement.
1 Turn Off the ice maker by raising the wire
signal arm.
2 Remove the lter by pushing on the end/
face of the lter.
3 Slide the old water lter cartridge straight
out of the housing and discard it.
4 Unpackage the new lter cartridge. Using
the alignment guide, slide it gently into the
lter housing until it stops against the snap-in
connector at the back of the housing.
5 Push rmly until the cartridge snaps into
place (you should hear a click as the
cartridge engages the snap-in connector).
6 Turn On the ice maker by lowering the wire
signal arm.
7 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red
to Green, the status has been reset.
8 After replacing the water lter and in order for
the ice maker to work properly, it is necessary
to clear air from water lter tubing. Once ice
maker begins making ice, allow the bucket to
ll completely, then discard the rst TWO FULL
buckets of ice. It will take at least two days
to completely ll the bucket on regular ice
making mode or 1½ days on fast ice mode.
The PureSource Ultra
TM
ice
and water lter system is tested
and certied to NSF/ANSI
Standards 42 and 53 for the
reduction of claims specied on
the performance data sheet.
More about your Advanced
Water Filter
FRIGIDAIRE &
FRIGIDAIRE GALLERY
Commentaires sur ces manuels