IMPORTANT
Before starting a cycle, run hot water to
clear cool water from pipe.
14
Rinse Aid
Rinse aid greatly improves drying, reduces
water spots, fi lming. With it water “sheets”
off dishes rather than forming water droplets that
cling and leave spots.
A dispenser, located next to the detergent cup,
automatically releases a measured amount of rinse
aid during the last rinse. If spotting and poor
drying are problems, increase the amount of rinse
aid dispensed. The indicator will be dark when full
and will show clear when it is time to refi ll.
Do not overfi ll since this can cause oversudsing.
Wipe up any spills with a damp cloth.
The dispenser holds enough for 11 to 66 washes,
depending on setting.
To add liquid rinse aid, open the cover. Pour in
rinse aid until liquid touches the indicated fi ll level.
Close the cover.
FACTORS AFFECTING PERFORMANCE
Water Pressure
The hot water line to dishwasher must provide
water pressure between 20 and 120 psi.
Low water pressure may occur when laundry or
showers are in operation. If you experience poor
wash performance you may need to wait until
water use is reduced before starting dishwasher.
Selecting the HI-TEMP WASH option in
combination with Rinse Aid will enhance drying
performance. You may choose to select the AIR
DRY option; however you will have items in your
dish load that will not be completely dry at the
end of the cycle. The energy required to not use
the AIR DRY option saves pennies per cycle.
How to adjust the rinse aid dosage
Press and hold the RINSE ONLY and DELAY START
Press and hold the RINSE ONLY and DELAY START
pad until the display shows rinse aid level (L0-L6).
pad until the display shows rinse aid level (L0-L6).
Pressing the DELAY START pad increases the
Pressing the DELAY START pad increases the
increment level (L0-L6).
Once the rinse-aid level reaches L6, the display
Once the rinse-aid level reaches L6, the display
will start back at level L0.
will start back at level L0.
Pressing the START button or just pausing for a
few seconds confi rms the rinse aid level setting:
the display shows the duration of the cycle.
Water Temperature
Hot water is needed for best dishwashing and
drying results. Water entering dishwasher should
be at least 120
o
F (49
o
C) to give satisfactory
results.
To check water temperature entering dishwasher:
• Turn on hot water faucet nearest dishwasher
for several minutes to clear cool water from
pipes.
• Hold a candy or meat thermometer in the
water stream to check the temperature.
• If temperature is below 120
o
F (49
o
C), have
a qualifi ed person raise the hot water heater
thermostat setting.
Indicator
Rinse Aid
Compartment
Rinse Aid
Cover
NOTE
Í
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels