Frigidaire FGCD2456QB Guide du propriétaire télécharger pdf (Page 5)

OPERATING INSTRUCTIONS

Wash Cycle Selections

Cycle times are approximate and will vary with

options selected. Hot water is necessary to

activate dishwasher detergent and melt fatty food

soils. An automatic sensor will check the incoming

water temperature and, if it is not hot enough,

the cycle will be lengthened for automatic water

heating in the main wash and ﬁ nal rinse of all

cycles. This happens even when HI-TEMP WASH

option has not be selected. When HI-TEMP WASH

is selected, an even higher temperature will be

reached to handle heavier soil loads.

Option Selections

Hi-Temp Wash Option

HI-TEMP WASH option is selected, by pressing

the WASH TEMP pad, the dishwasher heats water

in the main wash to approximately 140

F (60

C).

This increase in water temperature helps

dishwasher detergent remove food grease and

soil from dishes more effectively and aids in

drying.

Air Dry

The AIR DRY will reduce temperature in the drying

phase of the selected cycle. This otion will slightly

decrease energy usage but will increase the

likelihood that dishware will not be dry.

Sanitize Option

To sanitize your dishes and glassware, select

SANITIZE option, the light will come on

and remain on until end of cycle.

The water

temperature in the ﬁ nal rinse will be raised to

155

F (68

C) and will maintain that temperature for

9 minutes. This option is available in Heavy and

Normal Cycles. Only these sanitization cycles have

been designed to meet NSF requirements.

The cycle time will be extended until the proper

water temperature is reached.

Washing action will

continue during the water heating delay. For best

results, the incoming water temperature should be

at least 120

F (49

C).

The sanitize criteria may not be satisﬁ ed if there is

an interruption of the cycle, power failure or if the

incoming water temperature is below 120

F (49

C).

To turn off the SANITIZE option, press the

SANITIZE pad again. The SANITIZE light will turn

off.

Delay Start

The DELAY START option allows you to

automatically delay starting your dishwasher from

1-24 hours.

To activate press the DELAY START pad until the

desired delay time shows in the STATUS window

and press START.

To cancel the DELAY START option and begin the

cycle before the delay period is over, press the

Cancel and then the Start pad.

Child Lock Controls

To prevent children from accidently changing the

dishwasher cycle or starting the dishwasher, lock

the dishwasher controls by pressing the AIR DRY

pad for 3 seconds. An indicator light on the lock

graphic pad will illuminate when the controls are

locked. To unlock the controls, press the AIR DRY

pad until the indicator light goes out.

To Cancel a Cycle

To cancel a cycle at anytime, open the door and

press the CANCEL pad until the 1 min drain feature

is initiated. Close the door and the drain cycle

will begin. You will hear a tone for the start and

completion of the drain cycle. When the door is

opened, the last cycle selected will be displayed.

If desired, a new cycle can now be selected by

pressing START pad and upon closing the door the

cycle will begin.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Frigidaire FGCD2456QB Guide du propriétaire Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Frigidaire FGCD2456QB