Frigidaire FH30DD50MS Manuel d'utilisateur télécharger pdf (Page 11)

DUCT TAPE OVER SEAM AND SCREW

Screw

Air Flow

Duct Tape Over

Seam and Screw

DUCT ON-THE-FLOOR

DUCT THROUGH-THE-FLOOR

6. Install Ductwork

- Use galvanized or aluminum duct in 6” round or 3 ¼” x

10” size, or a combination of both. PVC duct should be used

if installing under a poured concrete slab. Use the shortest

and straightest duct run possible.

The system will operate most efciently when the ductwork

does not exceed 60 feet of equivalent duct. The downdraft

will operate properly with ductwork up to 100 equivalent feet

of duct. See page 12 for Calculated Duct Length Table.

INSTALLATION

7. Connect Downdraft to Power

- Plug the downdraft’s power cord into the outlet.

- Make sure the power cord is routed beneath the appliance

and away from heat generated by the cooktop.

8. Install Cooktop

- Align the cooktop with the downdraft and fasten cooktop

in place.



NOTE

Local building codes must be followed in specifying

approved type and specication of ALL duct used. Always

use an appropriate roof or wall cap with damper.

IMPORTANT

All ductworks must be installed as per local codes.



NOTE

Accurate alignment of cooktop and downdraft is necessary

to ensure that there is no interference when air vent

is raised and lowered. There should be a gap of 1/8”

between the back of the cooktop and the front of the

downdraft cover.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Frigidaire FH30DD50MS Manuel d'utilisateur Page 11