Frigidaire FFHB2740PS Guide d'utilisation et d'entretien télécharger pdf (Page 21)

IMPORTANT

Your ice maker is turned on at the factory so it

can work as soon as you install your refrigerator.

If you cannot connect a water supply, set the

ice maker’s On/Off icon to Off; otherwise, the

icemaker’sllvalvemaymakealoudchattering

noise when it attempts to operate without water.

IMPORTANT

On occasion, unusually small ice cubes may

be noticed in the bucket or in dispensed ice.

This could occur in normal operation of the

ice maker. If you start seeing these more

frequently,itmaybeanindicationoflow

waterpressureorthewaterlterneedstobe

replaced.Asthewaterlternearstheendofits

useful life and becomes clogged with particles,

less water is delivered to the ice maker during

each cycle. Remember, if it’s been six months or

longersinceyoulastchangedyourwaterlter,

replacethewaterlterwithanewone.Poor

qualityhouseholdwatermayrequirethelter

tobechangedmorefrequently.

IMPORTANT

Turning off the ice maker simply disables ice

making. You will still be able to dispense existing

ice, and you will still be able to dispense water.

AUTOMATIC ICE & WATER DISPENSER



NOTE

The water dispenser has a built-in device that

shutsoffthewaterowafterthreeminutesof

continuous use. To reset this shutoff device,

simply release the dispenser paddle.



NOTE

The ice maker also has a built-in plastic signal

arm that automatically stops ice production

when the ice bin is full. This signal arm should

not be used to manually stop the ice maker.

CAUTION

For proper dispenser operation, recommended

water supply pressure should fall between

30 psi and 100 psi. Excessive pressure may

cause the system to malfunction.

Priming the water supply system

 1 Beginllingthesystembypressingand

holding a drinking glass against the water

dispenser paddle.

2 Keep the glass in

this position until

water comes out

of the dispenser.

It may take about

1½ minutes.

3 Continue

dispensing water

for about four

minutestoush

the system and

plumbing connections of any impurities

(stopping to empty the glass as necessary).

Ice maker operation & care

After the refrigerator is installed properly and

has cooled for several hours, the ice maker can

produceicewithin24hours.Theicemakerwillll

the ice bin from the rear. You must dispense some

ice to force the ice forward in the bin. This will

allowthebintollcompletely.

Ice Maker and Storage Bin Capacity

This ice maker should produce 2.5 to 3 pounds of

ice per 24 hours.

In a Standard Depth model, the ice bin will hold

about 6.5 pounds of ice. In a Counter Depth

model, the ice bin will hold about 4 pounds of ice.

Turning the fresh food ice maker

on and off

Ice production is controlled by the ice maker’s

On/Off icon on the control panel. Touch the

“options” button to access the Options Menu on

the control panel. Use "∨” or "∧” to select the ice

maker. Then use “+” or “-” to select ON or OFF.

Touch “set” to activate your choice.

Using the ice maker after installation

Beforemakingiceforthersttime,besure

to prime the water supply system. Air in new

plumbing lines can result in two or three empty

ice maker cycles. Furthermore, if the system is not

ushed,thersticecubesmaybediscoloredor

haveanoddavor.



NOTE

Dispensed water is chilled. For colder water, add

ice to cup or container before dispensing water.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 40 41

Commentaires sur ces manuels

Pas de commentaire

Frigidaire FFHB2740PS Guide d'utilisation et d'entretien Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs-congélateurs côte à côte Frigidaire FFHB2740PS