Frigidaire FFRE1833U2 Schéma de câblage Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 9
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
Extend Window Filler Panels and attach to top angle rail:
6
5
Installation Instructions
1. Carefully raise window to expose filler panel locking screws on top angle rail. Loosen screws so filler panels slide
easily.
2. Extend panels to fill window opening completely. Tighten locking screws on top (FIG. 16).
3. Close window behind top angle rail.
4. Attach the top angle rail to window frame: Use a 3/32” drill bit to drill one hole through the hole in the middle of top
angle rail into the window frame, and drive one 1/2” HEX-HEAD locking screw through the hole in the middle of top
angle rail into the window frame as shown (FIG. 17).
Install Window Sash Seal and Safety Lock
8
1. Trim window sash seal to fit window width. Insert it into
space between upper and lower sashes as shown (FIG. 20).
2. Attach right angle safety lock to top window sash as
shown (FIG.21).
3. If necessary, trim weather seals to needed length, peel
off protective backing, and use to plug any gaps. See Fig. 19.
Install Air Conditioner into Cabinet and Install Front Panel to Unit
9
1. Lift air conditioner and carefully slide into cabinet.
2. CAUTION: Do not push on controls OR finned coils.
3. Be sure air conditioner is firmly seated towards rear of cabinet.
4. Reconnect electronics plug if present. Hook front panel top tabs into slots on cabinet top, and rotate front panel
down so that side tabs snap into place on cabinet. Insert 4 previously removed screws through front panel and into
air conditioner.
5. Insert air conditioner filter. Reinstall the front grille by hooking bottom tabs into slots on Front Panel bottom, then
rotating grille up to snap into place.
A. 1/2” long hex head screw
B. left-hand Window Filler
Panel Top Leg
C. Window channel
A. 1/2” long hex head screw
1. Extend the window filler panels out against the window frame.
2. Use a 1/8" drill bit to drill a starter hole through the hole in the
top leg of each window filler panel and into the window sash
(Fig. 18 and Fig. 19). Connect with one 1/2" long hex head
screw.
Attach Window Filler Panels to Window Frame
7
A
FIG. 19
SAFETY LOCK
FIG.21
1/2 long
hex-head
screws
C
B
FIG. 18
A
Window Sash
WINDOW
SASH SEAL
FIG.20
LOCKING SCREWS
FIG.16
7/16” Locking Screw
and Washer
1/2” long
HEX-HEAD
SCREW
FIG. 17
Vue de la page 4
1 2 3 4 5 6 7 8 9

Commentaires sur ces manuels

Pas de commentaire